Ocean Kayak SCUPPER PRO 14561 User Manual download pdf

Ledge (for

steering track)

Ledge (for

steering track)

Notch (vertical surface for

tubing and steering lines)

Notch (vertical surface for

tubing and steering lines)

Notch (vertical surface for

tubing and steering lines)

Notch (vertical surface for

tubing and steering lines)

Rudder mount

(insert nylon sleeve)

6-inch hatch (needed

to install steering lines)

BOW STERN

Scupper Pro Rudder Installation Instructions (1997 or newer models)

This kit is designed for the Scupper Pro with rudder mount and notches, first shipped October 29, 1996, serial numbers greater than XKA11274. Your Pro must

also have the front and center hatches to allow acess to the hull for rudder installation.

Parts Included:

1 rudder assembly (300386)

2 steering tracks with slides and pedals

(300107)

2 lengths of tubing (300153)

2 steering lines (300084)

1 nylon sleeve (300077)

4 long machine screws (300163)

4 well nuts (300162)

1 clam cleat (300099)

1 strap eye (300048)

2 adhesive-backed strap eyes (for 2-hatch Pro)

(300104)

4 self-tapping screws (300036

2 short machine screws (300110)

4 rubber grommets (300097)

Tools Needed:

drill

3/8” drill bit

7/16” wrench

knife

phillips screwdriver

pen or marker

hammer

small block of wood

soapy water

duct tape

stiff wire (for TW)

Drill Tubing Holes

1. You must first drill holes at the center of each notch (3, 4, 5, 6). Hold the drill at 90 degrees to the vertical surface

of the notch, and hold it tightly to keep the drill straight through the layer of plastic.

2. Smooth any rough patches where you have drilled. Insert each of the 4 rubber grommets into each of the drilled

notches. Tubing and steering lines will run through the kayak at these points.

Call your local dealer or Ocean Kayak if you have questions. 800-8-KAYAKS or 360-366-4003. Or e-mail [email protected].

14561

1 2 3 4

6-inch hatch (needed 1

Summary of Contents

Page 1 - 6-inch hatch (needed

Ledge (forsteering track)Ledge (forsteering track)Notch (vertical surface fortubing and steering lines)Notch (vertical surface fortubing and steering

Page 2

Install Tubing1. Use a knife to cut the ends of the tubing at an angle to make inserting the tubing easier. Lubricate one length of tubing withsoapy

Page 3

Attach Rudder to Kayak1. Lubricate the nylon sleeve with soapy water and insert it in the top of the rudder mount (7).2. Place a small wooden block

Page 4

Helpful Hints & Troubleshooting:After a long car trip or a long-distance paddle, make sure all the screws are tight.To prevent fraying in any of t

Comments to this Manuals

No comments

Ocean Kayak SCUPPER PRO 14561 User Manual

Browse online or download User Manual for Knives Ocean Kayak SCUPPER PRO 14561. Ocean Kayak SCUPPER PRO 14561 User's Manual

Summary of Contents

Comments to this Manuals